LOBA WaxRefresher 1L

• Remove loose dirt and dust in advance with a vacuum cleaner, broom or mop.
• Observe general and, if applicable, product-specific occupational health and safety regulations.
• Shake material well.

Thinner / Mix

Water.

Application device / Material consumption

LOBA mop. On large areas, use a suitable flat mop or scrubber-suction machine. / Depending on the area of application, add approx. 200 – 1000 ml to a bucket of 10l water, sufficient for 100m². In the case of heavy soiling, the dosage can be correspondingly higher. Drying time: approx. 60 min.

Application:

Primary care:

If initial care with a LOBA NatureWax or ParkettWax is not possible, add 1l of WaxCleaner to 10l of water and use it to wipe the final or thoroughly cleaned floor coverings. After drying, the surface can be polished.

Maintenance cleaning (manual):

Add 200-300ml of WaxCleaner to 10l of water and use it to wipe the floor coverings with a mop. Allow residual moisture to dry.

Maintenance cleaning (mechanical):

Add 200-300ml of WaxCleaner to 10l of water and wipe the floor coverings with a scrubbing and suction machine. Direct suction should be avoided so that the residual moisture on the surface can dry and a sufficient care effect can be achieved.

Attention:

The area must not be flooded with the cleaning solution. The use of too much water in combination with too long exposure time can cause swelling in parquet, wooden floors and cork coverings and must therefore be avoided.